 |
|||
|
Page Title:
Cartridge, Impulse, M94, Drawing 8596708, covering a detail of Drawing 10520875 |
|
||
| ||||||||||
|
| MIL-T-46591B
4.1.3 Inspections. Inspections shall be in accordance with MIL-A-2550 and MIL-STD-453.
4.2 Inspection provisions.
4.2.1 Lot.
4.2.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation, and
identification of lots shall be in accordance with MIL-STD-105.
4.2.1.2 Size of lot. The production lot size shall be as specified in the contract (see 6.2).
4.2.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed in accordance with the classification of defects.
Four power (4x) magnification may be used for inspection of such defects as burr and foreign matter. When
compliance with the applicable requirement is in doubt as a result of visual examination, the characteristic
shall be measured or gaged to determine acceptability. All nonconforming material shall be rejected.
4.2.2.1 Cartridge, Impulse, M94, Drawing 8596708, covering a detail of Drawing 10520875.
Characteristics
Defect
Method of Inspection
Critical
1
Mixed cartridges
Visual
2
Metal defective
Visual
3
Marking missing, incorrect, or illegible
Visual
Major
101
Foreign matter present
Visual
Minor
201
Case scratched or dented
Visual
4.2.2.2 Assembly, Drawing 10520875, less Cartridge, Drawing 8596708.
Critical
1
Any part missing
Visual
2
Improper assembly
Visual
3
Evidence of fluid in cartridge chamber
Visual
4
Evidence of fluid on exterior surfaces
Visual
5
Gas port at base of cartridge chamber obstructed
Visual
Major
101
Threads damaged
Visual
102
Foreign matter
Visual
Minor
201
Protective finish inadequate or defective
Visual
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals