 |
|||
|
|
|||
| ||||||||||
|
| MIL-T-46605B
4.5.1 Lot.
4.5.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation and
identification of lots shall be in accordance with MIL-STD-105.
4.5.1.2 Size of lot. The production lot size shall be as specified in the contract.
4.5.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed on a defect basis in accordance with the
classification of defects. Four power (4x) magnification may be used in performing visual examination for
such defects as burr and foreign matter. Inspection for rubber O-rings shall be in accordance with MIL-STD-
413. When compliance with the applicable requirement is in doubt as a result of visual examination, the
characteristic shall be measured or gaged to determine acceptability. All nonconforming material shall be
rejected.
4.5.2.1 Pin, Shear, Firing Pin, Drawing 10520486, covering a detail of Drawing 10520974.
Characteristics
Defect
Method of Inspection
Critical
None defined
Major
101
Diameter, max
Gage
102
Total length, min
Gage
103
Metal defective
Visual
104
Protective finish inadequate or defective
Visual
105
Burr or sharp corner
Visual
106
Foreign matter
Visual
Minor
201
Total length, max
Gage
202
Surface finish improper
Visual
4.5.2.2 Pin, Shear, Piston, Drawing 10520487, covering a detail of Drawing 10520974.
Critical
None defined
Major
101
Diameter, max
Gage
102
Total length, min
Gage
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals