 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-46780D(AT)
body consisting of removable sides and ends, troop seats and lazy backs, safety straps, bows,
paulin, end curtains and tailgate shall be furnished with each M756A2 vehicles.
3.3.9.6 Lubrication and lubricants. All accessories and body surfaces requiring
lubrication shall be lubricated with Military lubricants specified in Table IV for the ambient
temperature.
3.3.9.7 Instruction plates. Each vehicle shall be equipped with instruction plates,
including warnings and cautions suitably located, describing any special procedures to be
followed in operating the equipment. Instruction plates shall be in accordance with applicable
drawings, and shall meet performance requirements of MIL-P-514.
3.3.9.8 Welding. Welding required for construction of the body shall meet requirements
of MIL-STD-l261, unless otherwise specified (see 6.2).
3.3.9.9 Lifting. Truck, maintenance pipeline construction M756A2 w/w with the
A-frame attached at the rear shall be capable of transporting a suspended 3000 pound load a
distance of 50 feet without damage to the vehicle or any of its components.
3.3.10 Van type trucks. Van type trucks.
3.3.10.1 Waterproofness. The van bodies and all components shall be waterproof to
preclude the entrance of water due to rain, melting snow, and road splash as well as to prevent
the penetration of moisture resulting from other causes. Vapor barrier material shall be applied
to prevent possible accumulation of condensation on interior of van body. Prior to riveting the
seams shall be coated with sealer to provide a waterproof joint.
3.3.10.2 Lightproofness. Each van body with window blackout shades covering the
window and with access doors closed shall be lightproof sufficiently so that light from interior of
van is not visible from outside the van at night.
3.3.11 Truck, maintenance: earth borer pole setter (M764). The earth auger truck shall
consist of a modified M35A2 cargo and M45A2 truck chassis providing for power divider body
mounted winch outrigger and earth boring machine installations.
3.3.11.1 Body winch. The rear winch shall be a reversible drum type with a 700 foot
length 1/2" diameter cable capacity, with a positive drive cable leveling device. A winch shaft
shear pin with replacement instructions shall be incorporated to provide for a free-wheeling drive
sprocket in event of operational overload. Winch rated line pull at first cable layer on drum shall
be 15,000 lbs. maximum. A winch auxiliary shaft shall be provided to drive capstan, or wire
reel. Mounting shall resist a 15,000 pound line pull.
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals