Definitions of recurring major and minor defects

Page Title: Definitions of recurring major and minor defects
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-T-46780D(AT)

Process average =

Number of defects

X 100

Number of vehicle inspected

If the computed process average exceeds the specified AQL, 100 percent inspection shall be

performed and continued until such time that the process average for twenty consecutive vehicles

is less than the specified AQL.

6.4 The following definitions shall be used for the classification of defects for leaks:

Weep:

- Any evidence of fluid beyond the seal.

Seep:

- Any evidence of fluid beyond the seal that does not result in the

formation of a droplet

Droplet:

- Any evidence of fluid beyond the seal that results in the formation of

a droplet.

Drip:

- Any evidence of fluid beyond the seal where droplet forms and falls.

6.5 Definitions of recurring major and minor defects. The Government Inspector will

verify that a thorough inspection of each vehicle is performed by the contractor not only for the

listed characteristics, but also for any other departures from good workmanship. The

Government Inspector will assure that all deficiencies encountered during the inspection are

enumerated on the Deficiency Sheet for the vehicle. The defects noted on Deficiency Sheet shall

contain sufficient description to enable the Government Inspector and the contractors

representative to classify the deficiency in accordance with the classification of defects of the

vehicle specification and definitions contained in MIL-STD-105. Corrective action shall be

taken for recurring deficiencies.

6.6 Weight and loads. Weights and load allowances shall be in accordance with the

following (Table XIV),

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business