 |
|||
|
Page Title:
First article (initial Production) approval |
|
||
| ||||||||||
|
|  MIL-T-48604(MU)
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set
forth in the specification where such inspections are deemed necessary
to assure supplies and services conform to prescribed requirements.
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the quality assurance provis-
ions of this specification. Definitions of inspection terms shall be as
listed in MIL-STD-109.
4.1.2 First article (initial Production) approval. - The require-
ments for first article approval and the responsibility (Government of
contractor) for first article testing shall be as specified in the
contract. The sample for first article approval tests shall consist of
four tube assemblies manufactured in the same manner using the same
materials, equipment, processes, and procedures as used in regular
production. All parts and materials, including packaging and packing,
shall be obtained from the same source of supply as used in regular
production. The assemblies shall meet the requirements and tests of
Tables I, II, III. Prior to submission for first article test the
sample will have successfully passed the requirements of 3.4.1 through
3.4.2 inclusive (un-encapsulated tube).
4.1.2.1 Government testing. - When the Government is responsible
for conducting first article approval tests, the contractor, prior to
submitting the sample to the Government, shall inspect the sample to
insure that it conforms to all the requirements of the contract and
submit a record of this inspection with the sample, including certif-
icates of conformance for materials.
4.1.2.2 Contractor testing. - When the contractor is responsible
for conducting first article approval tests, the sample shall be in-
spected by the contractor for all requirements of the contract. The The
sample and a record of this inspection, including certificates of
conformance for materials, shall be submitted to the government for
approval. The Government reserves the right to witness the contractor's
inspection.
4.2 Inspection Provision.
4.2.1 Submission of product. - Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and presentation
of lots shall be in accordance with "Submission of Product" provisions
of MIL-STD-105.
4,2.2 Examination and tests.
4.2.2.1 Components and subassemblies. - All components and subassem-
blies shall be inspected in accordance with the provisions set forth in
this specification. Tube, ballast, resistor. connectors prior to encap-
sulation and the encapsulated assembly shall be inspected as identified
in this specification.
4.2.2.2 Fabrication.
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals