 |
|||
|
Page Title:
Key, Drawing 10534180, covering a detail of Drawing 11730535 |
|
||
| ||||||||||
|
| MIL-T-60561B
4.5.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed on a defect basis in accordance with the
classification of defects. Four power (4x) magnification may be used in performing visual examination for
such defects as burr and foreign matter. Inspection for rubber O-rings shall be in accordance with MIL-STD-
413. When compliance with the applicable requirement is in doubt as a result of visual examination, the
characteristic shall be measured or gaged to determine acceptability. All nonconforming material shall be
rejected.
4.5.2.1 Key, Drawing 10534180, covering a detail of Drawing 11730535.
Characteristics
Defect
Method of Inspection
Critical
None defined
Major
101
Surface finish incorrect
Visual
102
Protective finish inadequate or defective
Visual
103
Metal defective
Visual
104
Burr or sharp corner
Visual
105
Foreign matter
Visual
Minor
201
Total length
Gage
202
Length from end to vertical center
Gage
203
Length from top to true position of longitudinal center
Gage
204
Length from bottom of true position of longitudinal center
Gage
205
Width
Gage
206
Height
Gage
207
Radius or chamfer incorrect
Gage
208
Radius or chamfer missing
Visual
4.5.2.2 Pin, Firing, Drawing 8593864, covering a detail of Drawing 11730535.
Critical
None defined
Major
101
Concentricity of groove with body
Gage
102
Concentricity of striker with body
Gage
103
Concentricity of striker shoulder with body
Gage
104
True position of hole
Gage
105
Diameter of groove
Gage
106
Diameter of body, min
Gage
107
Diameter of striker, max
Gage
108
Diameter of hole, max
Gage
109
Profile of striker
Gage
110
Profile of groove
Gage
111
Metal defective
Visual
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals