 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62079E
3.4.9.5 Spare tire assembly. When specified (see 6.2), a spare tire assembly shall be
furnished. The spare tire assembly shall include an inflated spare tire mounted on the spare
wheel or rim. The spare tire shall be of the same size, tread design and load range (ply rating) as
the tires furnished on the vehicle.
* 3.4.10 Brakes. The manufacturer's standard power brakes shall be furnished. Brake linings
shall be of nonasbestos material.
3.4.11 Steering. Power steering shall be furnished.
3.4.12 Windshield wipers and washers. The vehicle shall be equipped with dual windshield
wipers and washers. Windshield wipers shall be of the multispeed type and operated by electric
motor(s).
3.4.13 Bumpers. Front and rear bumpers shall be provided.
3.4.13.1 Rear bumper. When side facing seats in the rear compartment and a rear entrance
door are furnished (see 3.5.1, 3.5.4.1 and 3.5.4.3), the rear bumper shall be a heavy duty channel
type, with a safety-tread step. The step shall be not less than 8 inches deep and shall extend not
less than the full width of the rear door(s). The step height shall be approximately half the
distance between the ground level and the body floor height.
3.4.14 Tools. When specified (see 6.2), each vehicle shall be furnished with tools required
for exchanging the mounted tire assembly with the spare assembly and shall include at least a
jack, a jack handle, and a wheel nut wrench. The jack shall be of such closed height as to permit
its location under the axle or other satisfactory lift point, at any wheel with a tire flat. The jack,
without blocking, shall be capable of raising any wheel of a loaded vehicle to a height adequate
to permit removal and replacement of the wheel and tire assembly. The tools shall not be stowed
in the rear passenger compartment.
3.4.15 Heater and defroster. A hot water heater shall be provided. The heater shall have
fresh air intakes. Discharge outlets shall be provided to direct heated air to the floor and to the
windshield defroster louvers. The heater shall be complete with blower and mounted controls
convenient to the driver. A rear compartment heater shall be furnished and protected with a
cover to prevent damage to the heater by the occupants. The heater control shall be located in
the driver's compartment in a location readily accessible to the driver.
3.4.15.1 Air conditioning. When specified (see 6.2), a driver's area air conditioning system
shall be furnished. A tinted safety glass windshield shall be furnished. When specified (see 6.2),
a rear compartment air conditioning system shall be furnished.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals