 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62110G
leaving the cab. When the front tires extend beyond the cab fenders, rubber fender extensions
extending at least to the outside of the tire tread shall be furnished. When tilt type cabs are
furnished, provisions to facilitate cleaning the windshield shall be provided by means of a
bumper step or bumper step cutouts and a grab handle located under the windshield. When step
height exceeds 24 inches, a secondary step shall be provided.
3.4.12.1 Cab interior. Unless otherwise specified, the cab shall have an upholstered, full
width, adjustable seat and back or individual, adjustable, driver's seat and individual passenger
seat. When specified (see 6.2), an individual, adjustable, driver's seat and an individual
passenger seat shall be provided. When specified (see 6.2), the driver's seat shall be the
manufacturer's standard air ride suspension type. The color of the upholstery and the interior
finish shall be compatible with the exterior color (see 3.1.1.1). White upholstery shall not be
furnished. Interior lighting shall be provided. Two pairs of seat belts shall be installed.
*
3.4.12.2 Crew cab. When specified (see 6.2), a four-door, full width crew cab shall be
furnished in lieu of the standard full width cab. The cab shall be equipped with two upholstered,
full width seats and backs. The front seat shall be adjustable. Three pairs of seat belts shall be
installed for both the front and rear seats. Cab doors shall be equipped with locks operable from
inside the cab through mechanical linkage, with both front doors equipped with an external key
operated lock. Cab doors shall have windows with crank operated window regulators. A rear
window shall be provided. Interior lighting shall be provided. Safety grips or grab handles shall
be provided at each door of the cab to assist personnel climbing into the cab. The cab roof shall
be of one-piece construction; or, if welded, the roof shall give the appearance of one piece, with
weld seams being continuous, waterproof , and free of visible seams, bumps or protrusions. Full
length drip moldings shall be mounted above the doors. When a crew cab is furnished, the
cab-to-axle dimension shall be measured from the back face of the crew cab.
3.4.12.3 Crew cab seat spacing. With the front seat adjusted to the extreme forward
position there shall be not less than 30 inches, measured in a horizontal plane, between the front
of the rear seat-back and the rear of the front seat-back. A kick-space height of not less than
2.75 inches shall be maintained between the floor and the rear of the front seat in all positions of
adjustment. Leg room and space forward of the front seat shall be equivalent to that provided
ahead of the seat in a two-door standard cab.
3.4.13 Steering. Power steering shall be furnished.
3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual
windshield wipers and windshield washers. The windshield wipers shall be multispeed type
operated by either air or electric motor(s).
23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals