 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62110G
(h)
Tachometer
(i)
Ash receptacle
(j)
Dual sunvisors
(k)
Armrest on driver's side
(l)
Driver's compartment ventilator other than window.
*
3.4.19.1 Rearview mirrors. Two outside rearview mirrors shall be furnished, one
mounted on each side of the cab. Each mirror shall be of the combination type having flat and
convex areas enclosed in a common housing. The flat portion shall have not less than 50 square
inches of reflective area. The convex portion shall have not less than 25 square inches of
reflective area. The mirrors shall have not less than two supporting arms.
3.4.20 Horn. The manufacturer's standard electric horn shall be furnished. When
specified (see 6.2), in addition, an air operated horn shall be furnished.
3.4.21 Engine hour meter. An engine hour meter having a totalizing mechanism of not
less than 9,999 hours shall be furnished for the chassis engine to register accurately the number
of hours of operating time. The meter shall be of rugged construction to ensure continuous
trouble-free performance under severe operating conditions. The engine hour meter shall be
mounted on the cab instrument panel or in the engine compartment in a readable location.
3.4.22 Front mounted winch. When specified (see 6.2), the vehicle shall be furnished
with a winch assembly, mounted on the front of the vehicle and powered by the vehicle's
hydraulic system (see 3.12). The winch shall conform to SAE J706. The winch shall be the
single drum type for hoisting and negotiating purposes and shall have one forward and one
reverse speed. Dual winch controls shall be furnished, one inside the cab and one at the front
bumper. The cab winch controls shall be so located as to provide no interference with the
entrance or exit of the driver. The winch shall have a rated single line pull capacity of not less
than 20,000 pounds on the bare drum. The winch shall be equipped with a hydraulic relief valve
set to restrict the line pull capacity to 22,000 pounds. The winch line speed on the bare drum
shall be between 15 and 30 feet per minute at an engine speed equal to 35 percent of engine
governed speed. The winch shall be wound with not less than 185 feet of 0.625 inch diameter,
preformed, 6x37, improved plow steel, independent wire rope core (IWRC) cable, and shall be
equipped with an end chain and hook. An integral, adjustable, automatic safety brake shall be
provided. The winch shall be equipped with a four-way roller guide assembly. The winch shall
be equipped with a shaft extension on the curbside with a capstan drive extension (AT&T type).
3.4.22.1 Winch drum guard. A winch drum guard shall be furnished. The guard shall
confine the cable to the area between the drum flanges. The guard shall consist of not less than
0.25 inch vertical side plates, conforming to the outside radius of the drum flanges. Six bars,
25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals