Click here to make tpub.com your Home Page

Page Title: Windshield wipers and washers
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-62145E
*  3.4.12 Cab, type I. The chassis manufacturer shall furnish any type of his standard or
optional non tilting full-width cab for type I stake and platform vehicles. When specified
(see 6.2), a cab with a forward tilting hood and fender assembly, including tilting and locking
mechanism, shall be furnished. Cab doors shall be equipped with locks, operable from inside the
cab through mechanical linkage, and with at least the curbside door equipped with external,
key-operated lock. Drip rails shall be installed above the cab doors. Unless otherwise specified,
the cab shall have upholstered, full-width, adjustable seat and back or individual, adjustable
driver's seat and individual passenger's seat. When specified (see 6.2), an individual adjustable
driver's seat and an individual passenger seat shall be provided. The color of the upholstery and
the interior finish shall be compatible with the exterior color (see 3.1.1.1). White upholstery
shall not be furnished. Interior lighting shall be provided. Manufacturer's standard fastenings
and two pairs of seat belts shall be installed. Safety grips shall be provided on each side of the
cab to assist personnel in entering and leaving the cab.
*  3.4.12.1 Cab, type II. Type II vans shall be furnished with a tilt type cab with a tilting and
locking mechanism, and shall be as specified in 3.4.12. Tilt cab features shall be in accordance
with the Employee Safety and Health Standards of Federal Motor Carrier Safety Regulation 399,
including the first step height, which shall be not more than 24 inches. Provisions to facilitate
cleaning the windshield shall be provided by means of a bumper step, or bumper step cutouts,
and a grab handle located under the windshield. Otherwise, the cab shall conform to 3.4.12.
3.4.13 Steering. Power steering shall be furnished.
3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual windshield
wipers and windshield washers. Windshield wipers shall be multispeed type operated by either
air or electric motor(s).
3.4.15 Bumpers. Unless the bumper is an integral part of the vehicle cab, a channel type
front bumper shall be provided on each vehicle.
3.4.15.1 Rear end protection. The rear end of the vehicle shall be protected in accordance
with Federal Motor Carrier Safety Regulation 393.86. A rear bumper shall be furnished
(see 3.6.13 and 3.7.12).
*  3.4.16 Stowage space. Stowage space of sufficient size to accommodate a vehicle jack,
hand tools, antiskid chains, and emergency reflective triangles shall be furnished for retaining
equipment during vehicle operation. Stowage space for these tools shall conform to 3.5.7.
3.4.16.1 Tools. When specified (see 6.2), each vehicle shall be furnished with tools required
for exchanging a mounted tire assembly with the spare assembly, and shall include at least a
hydraulic jack, jack handle, and wheel-nut wrench. The jack shall be of such closed height as to
permit its location under the axle, or other satisfactory lift point, at any wheel with the tire flat.
20

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business