 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62223B(AT)
(k) When specified (see 6.2), in lieu of subparagraph (h), an air dryer shall be furnished.
The air dryer shall be of the desiccant type.
3.4.12 Cab. A tilt type cab, with tilting and locking mechanism, shall be furnished. Cab
doors shall be equipped with locks, operable from inside the cab through mechanical linkage,
and with at least the curbside door equipped with external, key-operated lock. Drip rails shall be
provided above the cab doors. Unless otherwise specified, the cab shall have upholstered, full
width, adjustable seat and back or individual, adjustable driver's seat and individual passenger
seat. When specified (see 6.2), an individual, adjustable driver's seat and individual passenger
seat shall be provided. The color of the upholstery and the interior finish shall be compatible
with the exterior color (3.1.1.1). White upholstery shall not be furnished. Interior lighting shall
be provided. Manufacturer's standard fastenings and two pairs of seat belts shall be installed.
Safety grips shall be provided on each side of the cab to assist personnel in entering and leaving
the cab. Provisions to facilitate cleaning the windshield shall be provided by means of a bumper
step, or bumper step cutouts, and a grab handle located under the windshield. When step height
exceeds 24 inches, a secondary step shall be provided.
3.4.13 Steering. Power steering shall be furnished.
3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual
windshield wipers and windshield washers. Windshield wipers shall be multispeed type and
operated by either air or electric motor(s).
3.4.15 Bumpers. Unless the bumper is an integral part of the vehicle cab, a channel type
front bumper shall be provided on the vehicle.
3.4.15.1 Rear end protection. The rear end of the vehicle shall be protected in
accordance with Federal Motor Carrier Safety Regulation 393.86. A full width, channel type
rear bumper shall be provided.
3.4.16 Tool stowage. Stowage space of sufficient size to accommodate vehicle jack,
hand tools, antiskid chains, electrical lead-in cable, and emergency reflective triangles shall be
furnished for retaining equipment during vehicle operation. Stowage space for these tools may
be furnished inside the cab. When stowage space for these tools is located outside of cab, it shall
be weatherproof and shall provide for locking with a padlock or shall be provided with a
flushmounted, chrome, keyed lock.
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals