 |
|||
|
Page Title:
Carrier for spare tire assembly |
|
||
| ||||||||||
|
|  MIL-T-62299B(AT)
3.4.10.1 Tires. Tires shall be tube or tubeless type with highway
tread. Steel belted radial ply tires or, when specified (see 6.2), bias
ply tires, shall be furnished. Tires shall have a rated capacity at
least equal to the load imposed on each tire, measured at each wheel, at
the ground, with the vehicle loaded to required GVW. Tires shall
conform to Tire and Rim Association recommendations or to ZZ-T-381 with
a size designation system the same as the Tire and Rim Association.
3.4.10.2 Balancing. Each tire shall balance within practicable
limits. Wheels, hubs, and brake drums shall be effectively in balance.
Balancing shall be adequate to preclude wheel shimmy at all vehicle
speeds.
3.4.10.3 Carrier for spare tire assembly. Unless otherwise
specified (see 6.2), a carrier for a spare wheel or rim and tire
assembly shall be installed in an underbody skirt compartment. Threaded
fasteners, when used to secure the spare tire in the carrier} shall. be
constructed of or plated with corrosionresistant. material. The carrier
design shall enable removal or mounting of spare wheel assembly using
only the tools specified in 3.4.16.1.
*
3.4.10.4 Spare wheel or rim. When specified (see 6.2), a spare
wheel or rim shall furnished. When a spare tire assembly is
specified (see 3.4,10.5), a spare wheel. or rim shall be furnished.
3.4.10.5 Spare tire assembly. When specified (see 6.2), a spare
tire assembly shall be furnished- -- The spare tire assembly shall include
an inflated spare t-ire mounted on the spare wheel or rim. The spare
tire shall be of the same size and tread design and of the same load
range (ply rating) as furnished on the vehicle.
3.4.10.6 inner tubes. For tube type tires, inner tubes shall be
heavy duty type=nd shall be the proper size for the tires furnished.
a
Tire flaps shall be provided for tube type tires in accordance with Tire
and Rim Association recommendations.
3.4.11 Brakes. Brakes shall conform to Federal Motor Carrier
Safety Regulations 393.40 through 393.42(b), and 393.44 through 393.52.
3.4.11.1 Service brakes. The vehicle shall be equipped with
full-air brakes on all wheels. The braking system, complete with all
necessary components, shall include:
(a) Air compressor, unloader--head type, engine driven and
lubricated, air or water cooled, and having a capacity of not
less than 12 cubic feet per minute (cfm).
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals