 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62518A
upholstery shall not be furnished. Interior lighting shall be provided. Two pairs of seat belts
shall be installed. Outboard seats shall have combination pelvic and upper torso restraint seat
belts.
* 3.4.12.2 Crew cab. When specified (see 6.2), a four-door, full width crew cab shall be
furnished in lieu of the standard full width cab. The cab shall be equipped with two upholstered
full width seats and backs. The front seat shall be adjustable. Three pairs of seat belts shall be
installed for both the front and rear seats. Outboard front seats shall have combination pelvic
and upper torso restraint seat belts. The cab doors shall be equipped with locks operable from
inside the cab through mechanical linkage, with both front doors equipped with external
key-operated locks. Cab doors shall have windows with crank-operated window regulators. A
rear window shall be provided. Interior lighting shall be provided. The cab roof shall be of
one-piece construction; or, if welded, the roof shall give the appearance of one-piece, with weld
seams being continuous, waterproof, and free of visible bumps or protrusions. Full length drip
moldings shall be mounted above the doors. When a crew cab is furnished, the cab-to-axle
dimension shall be measured from the back face of the crew cab.
3.4.12.3 Crew cab seat spacing. With the front seat adjusted to the extreme forward
position, there shall be not less than 760 mm (30 inches) measured in a horizontal plane, between
the front of the rear seat-back and the rear of the front seat-back. A kick-space height of not less
than 70 mm (2.75 inches) shall be maintained between the floor and the rear of the front seat in
all positions of adjustment. Leg room and space forward of the front seat shall be equivalent to
that provided ahead of the seat in a two-door standard cab.
3.4.13 Steering. Power steering shall be furnished.
3.4.14 Windshield wipers and washers. The vehicle shall be equipped with dual windshield
wipers and windshield washers. Windshield wipers shall be multispeed type operated by air or
electric motor(s). When specified (see 6.2), and if electric motor wipers are furnished,
intermittent wipers shall be furnished.
3.4.15 Bumpers. Unless the front bumper is an integral part of the vehicle cab, a channel
type front bumper shall be provided, except when a front mounted winch is specified, a pipe type
front bumper may be furnished (see 3.4.22.2). The rear bumper shall conform to 3.5.1. Rear end
protection shall be provided and shall be in accordance with Federal Motor Carrier Safety
Regulation 393.86.
* 3.4.16 Tool stowage. Stowage space of sufficient size to accommodate a vehicle jack, hand
tools, antiskid chains (for outside tires on duals only) and emergency reflective triangles shall be
furnished for retaining equipment during vehicle operation. Stowage space for these tools may
27
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals