|
| ![]() MIL-T-62531(AT)
18 September 1986
MILITARY SPECIFICATION
TRUCKS, MILITARY, UP TO 5 METRIC TON
PAYLOAD, GENERAL SPECIFICATION FOR
This specification is approved for use by US Army Tank-Automotive Command, Department of
the Army, and is available for use by all Departments and Agencies of the Department of
Defense.
1. SCOPE
1.1 Scope. This specification covers general and special purpose diesel powered truck
chassis, trucks, and truck tractors of all sizes up to and including 5 metric ton payload. Trucks
may have single front and single rear axles, or single front and dual rear axles.
1.2 Applicability. The requirements and verification contained in this specification applies
to military design and non-development item (NDI) trucks. The vehicles shall be capable of
performing ground transport tasks in selected combat support and service missions.
1.3 Use. This specification cannot be used without supplemental information. The need for
this information is identified by blanks within this specification. Blanks not applicable should be
marked "N/A". The rational for the requirements in section 3 and the inspections in section 4 are
provided in the appendix. The appendix of this specification parallels sections 3 and 4 of the
general specification including corresponding numbers and titles. Each requirement and
inspection verification is supported by a rationale, guidance, and lessons learned statement.
Beneficial comments (recommendations, additions, deletions) and any pertinent data which may
be of use in improving this document should be addressed to: US Army Tank-Automotive
Command, ATTN: AMSTA-GDS, Warren, MI 48397-5000, by using the self-addressed
Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this
document, or by letter.
AMSC N/A
FSC 2320
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |