 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62531(AT)
3.13 Rustproofing. Vehicles shall be rustproofed in accordance with MIL-R-46164
(see 4.13).
3.14 Safety. Exposed components and systems, which are subject to high temperatures, high
pressures, electrically actuated or inherently hazardous, shall be provided with correct
safeguarding and insulating features. Suitable rollover protection and personnel restraint system
for the crew shall be provided which shall be consistent with vehicle application, i.e., high speed
off-road usage. Vehicle shall comply with all applicable requirements in MIL-STD-1180
(see 4.14).
3.14.1 Noise. The vehicle shall comply with both the exterior and interior noise limits
specified herein. Exterior Noise - The vehicle shall comply with the exterior noise requirements
as specified in MIL-STD-1474. Interior Noise - The steady state noise levels in personnel
occupied areas shall be below 85 db(A) when measured for maximum noise as specified in
MIL-STD-1474. The personnel occupied areas shall be each operator or crew position
(see 4.14.1).
3.14.2 Windshield wiper system. The windshield wiper system shall meet the requirements
specified in SAE J198 (see 4.14.2).
3.15 Servicing and adjustment. Unless otherwise specified (see 6.2), the contractor shall
service the vehicles for operational use prior to delivery. Such servicing fit and adjustment shall
include, as a minimum, the focusing of lights, the proper adjustment of the engine, electrical
system, brake system, seats, doors, windows, windshield, and windshield wipers, horn, hood,
tailgate, front wheel alignment and tire pressure. The chassis, engine and all running gear shall
be serviced with lubricants of the proper grade for the climatic conditions at the destination
point. Engine cooling system shall be serviced with a solution of ethylene glycol and water in
equal parts by volume (see 4.15).
3.16 Transportability. Vehicle shall be equipped with towing device and lifting and tiedown
provisions which shall be adequate for highway, rail, sea and air transport in accordance with
MIL-STD-209 and MIL-A-8421 (see 4.16).
3.16.1 Lifting eyes. Two lifting eyes shall be installed on the front and two on the rear of
the vehicle. Each lifting eye and its mounting shall withstand a load of at least ______ kg
without failure or permanent deformation when the load is applied at an angle up to
______ degrees from the longitudinal axis (see 4.16.1).
3.16.2 Pintle. A towing pintle at the rear of the vehicle shall be provided. The pintle
assembly shall be of the swivel type and conform to the size and strength described in
Drawing ____________. The assembly shall be furnished with mounting flanges and lubrication
fitting. The pintle assembly mounting surface shall be not more than ______ mm forward of the
rear most part of the vehicle. The mounting of the pintle assembly shall include reinforcements
to transfer pintle loads directly to the web of the chassis frame. Provision for attachment of
trailer safety chains shall be provided. Pintle height shall be ______ mm from the ground with
vehicle loaded to its rated cargo capacity (see 4.16.2).
17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals