 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-63443(AR)
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for Inspection. Unless otherwise
specified in the contract or purchase order, the supplier is
responsible for the performance of all inspection requirements
as specified herein. Except as otherwise specified, the supplier
may utilize his own facilities or any commercial laboratory
The Government reserves the right
acceptable to the Government.
to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies
and services conform to prescribed requirements.
4.1.1 General Provisions. The component and subassembly
inspection requirements of MIL-F-13926 form a part of the
Quality Assurance Provisions of this specification. Definitions
of inspection terms shall be as listed in MIL-STD-109.
4.2 First Article (initial production) Approval,
The
requirement for first article approval and the responsibility
(Government or Contractor) for first article testing shall be as
specified in the contract. The sample for first article approval
tests shall consist of (2) Aiming Circles plus (3) each of all
The sample shall be manufactured in the
items covered by SQAP.
same manner, using the same materials, equipment, processes, and
procedures, as used in regular production. All parts and
materials, including packaging and packing, shall be obtained
from the same source of supply as used in regular production.
4.2.2 Contractor Testing. When the contractor is
responsible for conducting First Article Approval Tests, the
sample shall be inspected-by the contractor for all the require-
ments of the contract.
The sample and a record of this inspec-
tion, including certificates of conformance for materials, shall
The Government
be submitted to the Government for approval.
reserves the right to witness the contractor's inspection.
Inspection Provisions.
4.3
4.3.1 Submission of Product. Unless otherwise specified by
the Contracting Officerr inspection lot size, lot formation? and
presentation of lots shall be in accordance with "Submission of
product" provisions of MIL-STD-105.
4.3.2 Examination and Tests. Components and subassemblies
shall be inspected in accordance with the insection provisions
contained in Supplementary Quality Assurance Provisions (SQAP)
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals