 |
|||
|
Page Title:
Table III. Electronic Characteristics-Cont. |
|
||
| ||||||||||
|
|  MIL-T-63534(AR)
TABLE III. Electronic character istics (continued)
Function
Connector
Characteristics
With output voltage present,
J2-S
Slow Slew Limit Signal Output
the impedance to ground is less
than 100 ohms. Impedance will
be greater than 1OOK ohms when
the output is off.
J2-T
Shield Return
Chassis ground.
J2-U
26.5 (+5) Vdc will enable the
Fixed Forward Mode Select Input
fixed forward mode.
J3-A
Left Limit Input Signal
Normally 28 Vdc when not at
limit (low level). Limit state
will be O ( 0.5) Wk.
J3-B
Right Limit Input Signal
Same input characteristics as
J3-A.
J3-C
Down Limit. Input Signal
Same input characteristics as
J3-A.
J3-K
Up Limit Input Signal
Same input characteristics as
J3-A.
J3-D
Stn EL Input
(Parallel with JI-R) 0-12 Vrms,
400 Hz +5% sinusoidal, input
impedance of 18K ohms minimum
in parallel with 0.047 F
through a normally closed relay
contact (Open when 28 Vdc on
J1-K).
J3-E
Sin EL Return to Turret
Low Level Ground (Parallel with
J1-S).
J3-F
Sin Az Cos EL Input Return to
LOW Level Ground bus.
the Turret
J3-G
Sin Az Cos EL Input
Parallel with J1-N. 0-12 Vrms,
400 Hz +5% sinusoidal, input
impedance of 18K ohms minimum
in parallel with a 0.047 F
through a normally closed relay
contact (open when 28 Vdc on
J1-K).
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals