Salt spray test

Page Title: Salt spray test
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-T-63536(AR)

4.6.2.1 Temperature. A high temperature test shall be performed in

accordance with MIL-STD-81O, Method 501.1. Procedure H, and a low temperature

test shall be performed in accordance with MIL-STD-810, Method 502.1, Procedure

I. The minimum temperature during the low temperature test shall be -65F,

and the maximum temperature during the high temperature test shall be +160C.

4.6.2.2 Altitude. A low pressure altitude test shaLl be performed in

accordance with MIL-STD-810, Method 500.1, Procedure I.

4.6.2.3 Temperature - altitude combination. A temperature - altitude

test shall be performed in accordance with MIL-STD-810C, Method 504.1,

Procedure I and equipment category 5.

4.6.2.4 Humidity. A humidity test shall be performed in accordance with

MIL-STD-81O, 507.1, Procedure I.

4.6.2.5 Vibration. A vibration test shall be performed in accordance

with MIL-STD-810, Method 514.2, Procedure I, Equipment Category C, except use

0.3 inch double Amplitude from 5 to 40 cps or 3 g acceleration, whichever is

less, and use 0.036 inch double amplitude from 40 cps to 73 cps and 10 g from

73 Cps to 500 Cps.

4.6.2.6 Shock. A shock test shall be performed in accordance with

MIL-STD-810, Method 516.2, Procedure I.

4.6.2.7 Sand and dust. A dust test shall be performed in accordance with

MIL-STD-810, Method 510.1, Procedure I.

4.6.2.8 Fungus. A fungus test shall be performed in accordance with

MIL-STD-810, 508.1, Procedure I.

4.6.2.9 Salt spray test. Samples shall be selected from each protective

o finished lot and subject to the salt spray test in accordance with the

procedures specified-in ASTM B 117. Unless otherwise specified on the

applicable drawing, the minimum exposure time shall be one and one half (1

1/2) hours using a 5% sodium chloride solution. Rejection shall be in

accordance with the applicable protective finish specification.

4.6.3 Electronic performance inspection methods and procedures. The

logic control assembly shall be tested for compliance with specified

electronic, test points, feed-through winding, power outputs, input/output

relationships, adjustments, fire voltage output load, and power supply fail

safe. Any assembly which fails to comply with the specified performance

characteristic requirements or evidences degradation of its operational

performance shall be classed defective. Test equipment and procedures shall

be satisfactory to the contracting officer.

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business