 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-740G
3.4.15 Dump truck. With the hydraulic system filled with engine oil of the type and grade
specified in table IV, for the applicable temperature, and adjustment completed, vehicle(s) shall
demonstrate performance requirements with loads specified herein during dumping operations.
The hydraulic system controls shall control and actuate the system to raise and lower the dump
body, and hold body in any position during the raising and lowering range of operation. The
controls shall operate without binding, interference, or failure, using hand effort only.
3.4.16 Drop side cargo body. The drop sides and tailgate shall raise, and lower freely,
without binding. The locking devices shall retain the sides and tailgate rigidly in closed position
without chatter or failure, using hand effort only. The drop sides shall be interchangeable from
left to right sides and from right to left.
3.4.17 Air transportability. All vehicles, except the M246A1, M246A2, M543A1, M543A2,
M291Al, M291A2, M291A2C, M291A2D, M816, M819, M820, M820Al and M820A2 models
shall be air transportable in phase II of airborne operations -without disassembly. The M246A1,
M246A2, M543A1, M543A2, M291Al, M291AID, M291A2, M291A2C, M291A2D, M816,
M819, M820, M820A1, and M820A2 models shall be capable of air transportability in phase III
airborne operations without disassembly. The M291A1, M291AID, M291A2, M291A2C,
M291A2D, M820, M820Al and M820A2 models shall be capable of air transportability in
phase II airborne operations by removal of body from chassis.
3.4.18 Radio-interference suppression. Each vehicle shall be radio-interference suppressed
in accordance with the tactical vehicle requirements of MIL-STD-461.
3.5 Painting, marking, and data plates.
3.5.1 Painting. The vehicle, body(s) and components shall be cleaned, treated, and painted
in accordance with MIL-STD-193, as specified for the appropriate service (see 6.2). Painted
surfaces shall be free of sags, runs, and thin areas.
3.5.2 Marking. Vehicle marking shall be in accordance with MIL-STD-642, as specified for
the appropriate service (see 6.2).
3.5.3 Data plates. Data plates shall conform to type III, composition A, class 2 of
MIL-P-514.
3.5.3.1 Data plates (bolster and stake trucks). The bolster truck, M748Al, M748A2, M815
and truck, stake, bridge transporting, M328A2 wo/w, M328A2 w/w, M328A1 w/w, and
M821 w/winch, shall have permanently located instruction warning and caution plates describing
any special procedure to be followed in operation, loading and servicing of the specified body.
3.6 Rustproofing. When specified (see 6.2), vehicles shall be rustproofed in accordance with
MIL-R-0046164.
3.7 Wood treatment. All wood parts shall be cleaned and treated in accordance with the
requirements of MIL-STD-193.
21
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals