 |
|||
|
Page Title:
Convenience Power Outlet installation |
|
||
| ||||||||||
|
|  MIL-T-81527B(AS)
3.4. 1.6.2.5.3 Contents. The Rear Frame shall contain the following
substructures:
(a) Convenience Power Outlet Installation
(b) Interconnecting Test Harriess Shelf
3.4.1.6.2.5.3.1 Convenience Power Outlet installation.
3.4.1.6.2.5.3.1.1 Function.
The Convenience Power Outlet installation
shall make utility power available at the Pallet Section Bench Assembly, and
shall provide the connection point to the user' s source of supply. The
Convenience Power Outlet Installation shall also serve the RF Section Sup-
port Assembly.
3.4.1.6.2.5.3.1.2 Form Factor.
The Convenience Power Outlet Instal-
lation shall consist of receptacle strip installed in a crossmember of the
Rear Frame 37 inches above deck level and a terminal strip with 3 terminal
points installed on the upper left side of the Rear Frame. The receptacle
strip shall contain eight convenience power outlets rated at 115 VAC, 25A,
The outlets shall be 2-pole, 3-wire, polarized and shall meet the require-
ments of MIL-C-3767.
These outlets shall receive power directly from the
primary ac power source and shall not be connected through the circuit
breakers but will be separately connected by the user.
3.4.1.6.2.5.3.2 Interconnecting Test Harness Shelf.
3.4.1.6.2.5.3.2.
Function.
The Interconnecting Test Harness Shelf shall
support portions of the Interconnecting Test Harness and the System Harness
which lie in the vicinity of the Receiver Section Bench Assembly.
The Interconnecting Test Harness Shelf
3. 4.1.6.2.5.3.2,2 Form Factor.
shall consist of two panels atop the overhead structure of the Rear Frame
with a bracket located atop the Rear Frame.
This bracket shall accommo-
date and support the connectors which form the interface between the
Interconnecting Test Harriess and the System Harness. Each of the panels
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals