 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-81734D(AS)
Repair or replacement of malfunctioning items.
Determination that repaired or replaced items are perform-
ing within allowable limits.
Program loading of computer non-destructive read-out (NDRO)
and bulk store devices.
3.3.4 Warmup time, Warmup time for the test set shall not exceed 5
minutes for standard conditions of 4.4 and 20 minutes for the extreme
temperature conditions of 3.2.3.2. Standby circuits may be used by the
test set to meet the warmup requirements.
3.4 Detailed functional requirements. Functional requirements of the
individual test set items shall be in accordance with the applicable
specifications of Table 1.
3.5 Workmanship.
Workmanship shall conform to MIL-STD-454, Require-
ment 9.
3.6 Elements. Elements requirements of the individual test set items
shall be as specified in the applicable specifications of Table I.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified, the supplier may utilize his own facilities or any commercial
laboratory acceptable to the Government. The Government reserves the right
to perform any of the inspections set forth in the specification where such
inspections are deemed necessary to assure supplies and services conform to
prescribed requirements.
4.2 General. Acceptance of the AN/A\VM-23(V) shall be solely on the
basis of this specification.
4.2.1 Classification. The AN/AWM-23(V) shall be classified as a pro-
duction model in accordance with MIL-STD-280: "A model in its final
form of final production design made by production tools, jigs, fixtures,
and methods. It employs standard parts (or nonstandard parts approved
by the agency concerned)." If it is necessary to depart temporarily
from the mandatory requirements (parts, processes, etc.) of the technical
documents, a form DD 1694 shall be prepared. Minor deviations shall be sub-
mitted to the Navy Technical Representative (NTR) for approval, Major and
critical deviations and waivers shall be submitted to Naval Air Systems
Command for approval in accordance with the contract. The DD Form 1694
(Request for Deviation/Naiver) shall be prepared as delineated in MIL-STD-480,
4.2.2 Individual items. Individual items of Table I of the AN/AWM-23(V)
will be accepted separately and independently.
-15-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals