 |
|||
|
|
|||
| ||||||||||
|
| MILT81821
-
When applicable, the Contractor shall obtain
the federal
3.3.3.4 Federal stock number.
stock number in accordance with MlLD26715.
3.3.3.5 Identification of product.
A legend plate containing the related series end item
designation and the applicable system designation therein shall be engraved in neat, welt-formed
Gothic characters approximately one (1) inch high on standard black-white-black engraving stock.
The plate on each trainer panel shall be readily visible to the students. The trainer panel number, it
a multipanel trainer, shall reincluded on the legend plate.
The name of each major part or assembly shall be engraved
3.3.3.6 Identification of parts.
photographed, etched, etc., by the most economical method on suitable nonferrous material in
neat, well-formed characters,
one-quarter (1/4) to one-half (1/2) inch high, on standard
black-white-black engraving stock plates, or black- anodized aluminum stock. The plates shall be
located on or adjacent to the corresponding part. Each major part or assembly shall have identical
markings and instructions on or adjacent to it as those on the actual related end item.
Applicable cover markings shall appear on both the
3.3.3.7 Cover marking requirements.
longer sides of the upper edge of each trainer cover. Inner dust/security covers shall be marked with
the appropriate security classification in red letters not less than two (2) inches high. The word
FRAGILE shall be appropriately marked on each of the four sides of the outer trainer cover using
red letters 2 inches high. Adjacent to these markings shall be a vertical red arrow and the legend
THIS SIDE UP in letters 1 inch high. Each outer cover shall be permanently and legibly marked
with the following information in three quarters (3/4) inch high white letters:
* (When applicable)
Federal Stock Number
*
Military Serial Number
*
Trainer Nomenclature
*
Panel No. * of * Panels
*
Configuration
Floor Loading
With
Without With
Length
Weight
Width
Height
Cubage
Casters Jack Pads
Casters
*PSI.
*lbs.
*†PSI.
*PSI.
*in.
*in.
*in.
*cu. ft.
Property of U. S. Government
*
Applicable data in shipping condition shall be entered.
Maximum single caster load.
†
Floor loadings shall be calculated in accordance with 3.7.2.1.
38
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals