 |
|||
|
|
|||
| ||||||||||
|
|  MILT8504B
STANDARD
FEDERAL
FEDSTD151
Metals; Test Methods
FEDSTD183
Continuous Identification Marking of Iron and
Steel Products
MILITARY
MILSTD163
Steel Mill Products, Preparation for Shipment
and Storage
MILSTD753
CorrosionResistant Steel Parts; Sampling, Inspection
and Testing for Surface Passivation
AND10104
Tubing, Steel, CorrosionResistant, Round, Standard
Dimensions for
MS33584
Tubing End Standard Dimensions for Flared
(Unless otherwise indicated, copies of federal and military specifications, standards,
and handbooks are available from the Standardization Documents Order Desk, Bldg
4D, 700 Robbins Avenue, Philadelphia, PA 191115094.)
2.2 NonGovernment publications. The following document(s) form a part of this
document to the extent specified herein. Unless otherwise specified, the issues of the
documents which are DOD adopted are those listed in the issue of the DODISS
specified in the solicitation. Unless otherwise specified, the issues of documents not
listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM A 262
Steels, Austenitic Stainless, Detecting
Susceptibility to Intergranular Attack in
ASTM E 112
Estimating the Average Grain Size of Metals
(Application for copies should be addressed to ASTM, 1916 Race Street, Philadelphia
PA 19103.)
AMERICAN NATIONAL STANDARDS INSTITUTE (ANSI)
ANSI B 46.1 Surface Texture (Surface Roughness, Waviness, and Lay)
(Application for copies should be addressed to ANSI, 1430 Broadway, New York, NY
10018.)
(NonGovernment standards and other publications are normally available from the
organizations that prepare or distribute the documents. These documents also may be
available in or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document
and the references cited herein, the text of this document takes precedence. Nothing in
this document, however, supersedes applicable laws and regulation unless a specific
exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. Heating of material shall be accomplished in air or protective atmosphere
which will provide a smooth gray surface free from carburization, nitriding, or other
deleterious surface effects.
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals