 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-85395(AS)
3.5.3.3 EMCON shroud assembly (887AS500).
The EMCON shroud assembly shall
contain a housing, radome, RF absorber, antenna hood, retainer strap assembly,
and a RFI seal subassembly which shall consist of RFI fingerstock and
retainer, a hinged door and a door operating mechanism.
3.5.3.4 Transit case (91OAS2OO).
The transit case shall consist of the case
assembly and cushioning material.
3.5.4 Controls. Two pushbutton control switches shall be located on the
front panel.
The "WPN TEST" pushbutton, when depressed, enables the command,
battery self test and RF detection subsystems. The "SELF TEST" pushbutton,
when depressed, shall enable the command and battery self test subsystems and
shall apply a sweep voltage to activate the RF detector circuit.
When both
pushbuttons are depressed, the battery self test subsystem shall be enabled.
Materials shall conform to DL 91OAS1OO.
3.5.5
Material.
Workmanship shall be in accordance with MIL-STD-454,
3.5.6 Workmanship
Requirement 9.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.
Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or
any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the Inspections set forth in
the specification, where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.2 Classification of inspections.
The inspection requirements specified
herein are classified as follows:
a. First article inspection (see 4.4).
b. Quality conformance inspections (4.5).
4.3 Inspection conditions.
Unless otherwise specified herein, all
inspections shall be performed in accordance with the conditions specified in
3.3,4.
4.3.1 Performance characteristics.
4.3.1.1 Before testing.
The test set shall satisfy the requirements for
interference control
(see 3.3.5) and warm-up time (see 3.3.3).
4.3.1.2 During inspection acceptance testing.
The test set shall satisfy the
requirements of Section 3.
First article tests shall be made on a test
4.4 First article inspection.
set representative of the production test sets to be supplied under the con-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals