 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-85395(AS)
5.4 Marking.
In addition to any special marking specified in the contract
(see 6.2.1), each unit package, intermediate and exterior container and
unitized load shall be marked in accordance with MIL-STD-129.
When specified
in the contract (see 5.2.1), the marking of domestic shipments shall be in
accordance with FED-STD-123.
6.
NOTES
6.1 Intended use. The intended use of the Guided Weapon Test Set
AN/DSM-139A is to perform a GO/NO-GO confidence check on the data link
subsystem in data link modified WALLEYE weapons after the weapon has been
installed on the carriage aircraft. The test set exercises both the command
and video portions of the weapon data link subsystem.
6.2 Ordering data.
Acquisition documents should specify the
6.2.1 Acquisition documents.
following:
Title, number, and date of this specification
a.
Frequency (detector subsystem) (see 3.5.1.2.2.1)
b.
c.
Selection of applicable levels of packaging and packing (see 5.2,
5.3).
d.
When a first article is required for inspection and approval (see 4.4,
6.3).
e.
When test procedures are to be modified or expanded (see 4.8).
6.2.2 Data requirements.
When this specification is used in an acquisition
which incorporates a DD Form 1423, Contract Data Requirements List (CDRL), the
data requirements identified below shall be developed as specified by an
approved Data Item Description (DD Form 1664) and delivered in accordance with
the approved CDRL incorporated into the contract. When the provisions of DAR
7-104.9 (n) (2) are invoked and the DD Form 1423 is not used, the data
specified below shall be delivered by the contractor in accordance with the
contract or purchase order requirements. Deliverable data required by this
specification is cited in the following paragraphs.
Data requirement title
Applicable
Paragraph
DID no.
no.
DI-T-4902
4.4.1
Report, First Article Inspection
4.5, 4.5.6.4.1
Reports, Production Inspection
DI-T-4904
4.5.3.2.1,
Procedures, Reliability Tests
DI-R-7035
4.5.3.3
4.5.4.2, 4.8,
Procedures, Production/Acceptance
DI-T-4903
4.5.6.3
Inspection
'20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals