 |
|||
|
|
|||
| ||||||||||
|
|  MIL-V-5527A
(May 1951)
6.4 Qualified Products List.- Products considered accepttable under this specifica-
tion are listed in QPL-527 (latest revision).
6.5 Provisions for Qualification Tests.- The right is reserved to reject any bids
on items which have not been subjected to the required tests and found satisfactory. The
attention of the manufacturers is called to this provision} and they are urged to request
authorization for tests of the items which they propose to offer to the Air Force or Navy
under this specification. Requests for authorization of tests together with certified
test reports showing conformance with all the requirements of this specification and the
manufacturer's assembly and detail drawings, and for information as to the marking and
forwarding of samples should be addressed to the Bureau of Aeronautics, Navy Department,
Washington 25, D.C., the Qualifying Service, with a copy to the Commanding General, Air
Development Force, Wright-Patterson Air Force Base, Dayton, Ohio.
6.5.1 It is to be understood that upon receipt of the Letter of Authorization,
samples shall be furnished at no cost to the Government, and that the manufacturer shall
pay the transportation charges to and from the designated point where tests are to be made.
In the case of failure of the sample or samples submitted, consideration will be given to
the request of the manufacturer for additional tests only after it has been clearly shown
that changes have been made in the product which the Government considers sufficient to
warrant additional tests.
6.6 Detail and Assembly Drawinqs.- Detail and assembly drawings of the relief
valve shall be furnished, in duplicate, for each new model valve. Assembly drawings shall
show a cut-away section of all details in their normal assembled position and shall carry
part numbers of all details and subassemblies. The following data shall be furnished on,
or together with all assembly drawings:
(a)
Mounting position and dimensions
Port dimensions
(b)
Over-all dimensions
(c)
Actual flow capacity
(d)
Actual pressure range
(e)
Dry weight
(f)
Method of adjusting pressure rating
(g)
Dismantling procedure and procedure for replacing
(h)
synthetic packings if used.
(i) Any special installation or operating instructions
considered necessary,
NOTICE: When Government drawings, specifications, or other
data are used for any purpose other than in connection with
a definitely related Government procurement operation, the
United States Government thereby incurs no responsibility
nor any obligation whatsoever; and the fact that the Govern-
ment may have formulated, furnished, or in any way supplied
the said drawings, specifications, or other data is not to
be regarded by implication or otherwise as in any manner
licensing the holder or any other person or corporation, or
conveying any rights or permission to manufacture, use, or
sell any patented invention that may in any way be related
there to.
custodian:
Navy - Bureau of Aeronautics
Other interest:
Air Force
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals