 |
|||
|
Page Title:
Preproduction inspection sample |
|
||
| ||||||||||
|
|  MIL-V-82443(OS)
3.6
Workmanship. The workmanship and finish shall be of
sufficiently high grade to insure satisfactory operation consistent with
the requirements of this specification. The assembly shall be thoroughly
clean and free of excess materials, chips, and loose or spattered foreign
materials. The standards of workmanship exhibited in any approved pre-
production sample, subject to any qualification stated in the Government's
notice of approval, shall be determinative of the requirements of the
contract relative to workmanship insofar as not specifically covered by
applicable specifications.
4.
QUALITY ASSURANCE PROVISIONS
Responsibility for inspection. Unless otherwise specified
4.1
in the contract or purchase order, the supplier is responsible for the
performance of all inspection requirements as specified herein. Except
as otherwise specified, the supplier may utilize his own facilities or
any commercial laboratory acceptable to the Government. The Government
reserves the right to perform any of the inspections set forth in the
specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.2
Classification of inspection. Inspection of the valve shall
be as classified as follows:
a.
(Subsection 4.4)
Preproduction inspection
Acceptance inspection
(Subsection 4.5)
b.
c.
(Subsection 4.6)
Periodic inspection
Sampling.
4.3
4.3.1
Preproduction inspection sample. A preproduction sample of
12 values, manufactured in accordance with 3.2 shall be subjected to
the preproduction tests listed in Table IV and detailed in 4.4 through
4.4.4.17 at an activity designated by the procuring activity. In addition,
a quantity of 25 sample squibs shall be subjected to the tests detailed
in 4.5.7 through 4.5.7.5. Acceptance of the preproduction sample shall
be based on no defects in the sample. See 4.4.6. Further production of
the valve by the supplier, prior to approval of the preproduction sample
shall be at the supplier's risk.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals