 |
|||
|
Page Title:
Wiring diagram (drawing number 11022501) |
|
||
| ||||||||||
|
|  MIL-W-45992A(AL)
Constant Voltage Characteristics (CV)
(g)
Auxiliary Power KVA, AC Voltage, Frequency, Phase,
(h)
Date of Manufacturer
(i)
Gross Weight
(j)
Contract or Order Number
(k)
National Stock Number.
(l)
The nameplate shall be marked with the above information in accordance with
MIL-STD-130. The plate shall be aluminum conforming with Type III, Composition A,
Class 2 of MIL-P-514. The plate shall be attached to the equipment as specified on
Drawing Number 11021554.
3.3.12 Wiring diagram (drawing number 11022501). A wiring diagram depicting
actual machine wiring of the welding machine, protected with a transparent covering or
coating, shall be provided and fastened to the inside surface of the left door nearest
the control panel, when facing the control panel.
3.3.13 Lubrication chart and engine wirin g diagram (drawing number 11021573). A
lubrication chart and engine wiring diagram protected with a transparent covering or
coating shall be provided. The chart and diagram shall be permanently and securely
attached to the inside surface of the left door nearest the control panel, when facing
the control panel.
3.3.14 Ground rod. The welding machine shall be furnished with a Rod, Ground;
steel, copper clad, 5/8 inch (in) (15.875 millimeters (mm)) diameter, three 3 foot
(.914 meter (m)) sections with 6 foot (1.829 meters) cable No. 6 AWG with ground
terminal and ground clamp, in accordance with Federal Specification W-R-550, Type III,
Class B. Bus bar and hardware to mount ground terminal to the welder ground stud
shall be included.
3.3.15 Selector switch (drawing number 11022184). The welding machine shall be
furnished with a control panel mounted switch to provide for proper connection and
operation for accommodating and utilizing the Welding Set, Arc, Inert Gas Shielded in
accordance with Military Specification MIL-W-52161.
3.3.16 Ignition lock and keys. The welding machine shall be furnished with an
ignition lock and two identical ignition keys. The ignition key and lock for each
welding machine shall be different for a series of no less than 30 machines. The key
series and lock shall repeat on each group of machines.
3.3.17 Lubricating oil.
3.3.17.1 Engine. Engine lubricating oil shall be in accordance with MIL-L-2104
or MIL-46152 per engine manufacturers recommendations.
3.3.17.2 Air compressor. The air compressor (drawing 11022704) lubricating oil
shall be in accordance with MIL-L-46152 or MIL-L-2104 (A or B).
3.4 Performance and p roduct characteristics.
3.4.1 Physical data.
3.4.1.1 Weight. The operational ready weight - including engine oil; engine
coolant (55 percent ethylene glycol, 45 percent water by volume); full tank of fuel;
wet batteries; etc. - shall not exceed 2,637 pounds (lbs) (1196 kilograms (kg)) with
the air compressor kit and shall not exceed 2,405 lbs (1080 kg) without the air
compressor kit.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals