 |
|||
|
|
|||
| ||||||||||
|
|  MIL-W-47091A (MI)
1.2 Classification. Welding covered by this specification shall be classified
according to the base metal and shall be of the following types as specified (see 3.2).
a.
Type I
Mild steel, high strength mild steel, or low alloy steel
(see 6.2).
b.
Type II
Aluminum base alloys
c.
Type III
Magnesium base alloys
d.
Type IV
Corrosion resistant or stainless steel
2. APPLICABLE DOCUMENTS
2.1 Non-Government publications. The following documents form a part of
this document to the extent specified herein. Unless otherwise specified, the issues of
the documents which are DoD adopted are those listed in the issue of the DODISS
cited in the solicitation. Unless otherwise specified, the issues of documents not listed
in the DODISS are the issues of the documents cited in the solicitation (see 6.3).
SOCIETY OF AUTOMOTIVE ENGINEERS, INC (SAE)
AMS 3412
-
Flux, Aluminum Brazing
AMS 4375H
-
Magnesium Alloy Sheet and Plate 3.0A1-
1.0Zn (AZ31B-0) Annealed and Recrystallized
AMS 4376E
-
Magnesium Alloy Plate 3.0A1-1.0Zn (AZ31B-
H26) Cold Rolled and Partially Annealed
AMS 4377F
-
Magnesium Alloy Sheet and Plate 1.0Zn
(AZ31B-H24) Cold Rolled, Partially Annealed
(Application for copies should be addressed to the Society of Automotive
Engineers, Inc. 400 Commonwealth Drive, Warrendale, PA 15096.)
AMERICAN WELDING SOCIETY, INC. (AWS)
AWS WHB-1 CH6
-
Symbols for Welding and Inspection
AWS A3.0
-
Welding Terms and Definitions
Including Terms for Brazing,
Soldering Thermal Spraying and
Thermal Cutting
AWS A5.1
-
Carbon Steel Electrodes for
Shielded Metal Arch Welding,
Specification for
AWS A5.2
-
Carbon and Low Alloy Steel Rods
for Oxyfuel Gas Welding,
Specification for
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals