 |
|||
|
|
|||
| ||||||||||
|
|  MIL-W-50986A (AR)
3.6 Penetration. The loaded warhead shall function
satisfactorily as evidenced by complete detonation and penetration
of mild steel when tested as specified in 4.5.5.
Minimum
Stand-Off Distance
(Measured from tip of
Penetration
nose cap to target
Requirement
10.50 inches
0.0 inches
minimum
3.7 First article inspection. This specification makes
provision for First Article Inspection. Requirements for the
submission of First Article samples by the contractor shall be as
specified in the contract.
3.8 Workmanship. Unless otherwise specified on the drawing,
all parts and assemblies shall be free from burrs, chips, sharp
edges, cracks, unblended radi, surface defects, dirt, grease,
rust, porosity, warpage, burn marks, checks, blisters, excess
flash, corrosion products and other foreign matter. The cleaning
method used shall not be injurious to any part nor shall the parts
be contaminated by the cleaning agents. Surface coating shall be
continuous except for a few slight scratches not exposing base
material. The loading and assembly operations shall be performed
in a thorough, workmanlike manner consistent with the best
practices of the industry. All required markings shall be neat
and sharply defined. Cable assemblies and wires shall be dressed
in such a manner as to prevent pinching or chafing of the wire
insulation. Ends of wires shall be free from flux, chips, dirt,
grease, rust or foreign material.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspections Unless otherwise
specified in the contract, the contractor is responsible for the
performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract, the Contractor may
use his own or any other facilities suitable for the performance
of the inspection requirements specified herein, unless
disapproved by the government. The government reserves the right
to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements. Unless otherwise
specified herein or in the contract, the provisions of MIL-A-48078
shall apply and are made a part of this specification.
5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals