Click here to make tpub.com your Home Page

Page Title: Contractor designs.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-M-45013E (AR)
6.3.1 SIE designs. SIE designs may consist of any of the
following:
Detailed drawings which completely depict all information
a.
necessary for the fabrication and use of the item of
inspection equipment.
A source control drawing or a specification control
b.
drawing as defined in DOD-STD-100.
An envelope drawing, as defined in DOD-STD-100, which
c.
established the criteria which a detailed design shall
meet. When envelope drawings are specified, the
contractor shall prepare designs which comply with the
criteria therein.
6.3.2 Contractor designs. Contractor designs are requiared
for all inspection equipment for which SIE designs are not
specified and may include commercial eguipment which the
contractor proposed to use. (Commercial equipment is defined as
unmodified equipment which is cataloged and available for
purchase by the general public.) Contractor designs shall
include appropriate operating instructions, calibration Pro-
cedures and maintenance procedures. Commercial equipment shall
be fully described by catalog listings or other means, which
provide sufficient information to permit identification and
evaluation by the Government and may include illustrations and
engineering data. Designs shall be prepared foer any special
fixture(s) required to be used with conmercial equipment, or with
SIE designs if not otherwise covered (see 6.3.3.c). Designs
shall be of the category and form (per DOD-D-1000) specified in
the Contract Data Requirements List (DD Form 1423). The
specification number, paragraph number, and defect number from
Section-4 shall be referenced on each contractor design together
with the component or assembly drawing number, revision letter
and date to which the specific design applies.
6.3.3 Submission of contractor inspection equipment designs
for approval. Contractor designs shall be approved by the
Government prior to fabricating or procuring the equipment.
Designs shall be submitted for approval in accordance with the
stipulations, time frame and distribution specified in the
Contract Data Requirements Lists (DD Form 1423) or in the
contract. Partial submission of inspection equipment designs is
permissible and encouraged. However, the completion data for
design review will be based on the date of final submission of
designs and the required delivery schedule as stipulated in the
39

Privacy Statement - Press Release - Copyright Information. - Contact Us