 |
|||
|
|
|||
|
Page Title:
Inspection of production vehicles |
|
||
| ||||||||||
|
|  MIL-B-62152A(AT)
4.3.7 Production sample. Upon acceptance of the first production vehicle, it shall remain
at the manufacturing facility as a production samplet and be the last vehicle shipped on the
contract. The contractor shall maintain the vehicle in a serviceable condition for the duration of
the contract.
4.4 Inspection of production vehicles. Each production vehicle (less payload) shall be
examined and driven on approximately level road surfaces by the contractor to assure that the
vehicle will operate in accordance with the contractual requirements. The contractor may
authorize his sub-contractor who will perform the final assembly work on the vehicle to make
such examination and tests, but this shall not relieve the contractor of his obligation to deliver an
acceptable vehicle or constitute a waiver of any warranty provision. Each vehicle shall be tested
to determine that heating, air conditioning, lift platform, vacuum outlets, mechanical and
electrical systems are functional. Seat removal and litter kit installation shall be checked for
functional compatibility and completeness on at least one out of every five production units.
Seats shall be installed in normal position for shipment.
4.4.1 Rejection. Deficiencies of workmanship and nonconformance to any requirement
of the contract shall be cause for rejection until corrective action has been taken.
5. PREPARATION FOR DELIVERY
5.1 Vehicle processing. Vehicle shall be processed for shipment, from manufacturer's
plant to initial receiving activity, in accordance with manufacturer's standard commercial
practice.
6. NOTES
*
6.1 Intended use. The vehicle covered by this specification is intended for nontactical
use by the Government in the long distance transportation of ambulatory patients and conversion
to transportation of litter patients. The vehicle is to be used principally in transporting patients
between air terminals and hospitals and between hospitals and other points.
*
6.2 Ordering data. Procurement documents should specify the following:
(a) Title, number and date of this specification.
(b) Identification of appropriate service for painting and marking (see 3.1.1.1).
39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals