Click here to make tpub.com your Home Page

Page Title: Special marking
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-C-10578D
5.2.2
Level B.
5.2.2.1  1 and 2 gallon containers.  The compound packed in 1
or 2 gallon polyethylene bottles shall be packed in accordance
with 5.2.1.1 except that shipping container shall conform to PPP-
B-636, weather-resistant, W5c or W5s; PPP-B-621, class 1; PPP-B-
601, domestic type; or PPP-B-591, class 1.
5.2.2.2  5 and 15 gallon containers.  The compound in 5 or 15
gallon polyethylene containers shall be packed in exterior
shipping containers in accordance with level B requirements of
appendix to MIL-D-40030.
5.3  Marking.  In addition to any special marking required by
the contract or purchase order, shipping containers shall be
marked in accordance with MIL-STD-129, with the exception that
commercial marking in accordance with MIL-STD-1188 applies for
commercial packaging only.
5.3.1  Special marking.  In addition, each container shall be
conspicuously marked in accordance with MIL-STD-129, with a
caution warning and directions for use for the applicable type,
as follows:
CAUTION: Compound contains a strong acid.  Protect
hands, face, and eyes.  Wear rubber gloves,
apron and goggles.  If splashed on the skin,
flush with plenty of water, followed by a
water rinse containing 1 percent bicarbonate
of soda.  Avoid prolonged breathing of vapors.
DIRECTIONS FOR USE (as applicable for each particular type):
"Type I (Wash-off) material - Add 1 part of the concentrated
material as received to 3 parts of water by volume.  Use acid
resisting steel, earthenware crocks or other suitable mixing
tanks.  Remove heavy rust by wire brush and heavy grease with a
grease solvent before applying the compound.
After proper dilution, apply by spray, dip or flow-brush on clean
metal surfaces.  Allow the material to remain only long enough to
wet the surface in order to cause etch.  On rusted surfaces,
allow material to remain long enough to loosen the rust (from 2
to 10 minutes depending on the degree of rusting).  Then rinse
surface with water, preferably hot; permit to dry thoroughly
prior to application of rust preventive or paint."
10

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business