 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-24756(SH)
the right to perform any of the inspections set forth in this specification where such inspections
are deemed necessary to ensure supplies and services conform to pracribed requirements.
4.1.1 Responsibility for compliance. All items shall meet all requirements of sections 3 and
5. The inspection set forth in this specification shall become a part of the contractor's overall
inspection system or quality program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the responsibility of ensuring that all products or
supplies submitted to the Government for acceptance comply with all requirements of the contract.
Sampling inspection, as part of the manufacturing operations, is an acceptable practice to ascertain
conformance to requirements, however, this does not authorize submission of known defective
material, either indicated or actual, nor does it commit the Government to accept defective
material.
4.2 Classification of inspection. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.3)
b. Quality conformance inspection (see 4.4).
43 First article inspection If required, the first article shall be examined as specified in
section 4.5 for compliance with design, instruction, workmanship, appearance, and dimensional
requirements.
4.4 Quality conformance inspection. Sampling for inspection shall be performed in accordance
with MIL-STD-105, except where otherwvise indicated (see 6.2).
4.4.1 Component and material inspection. In accordance with section 4.1, components and
materials shall be tested in accordance with all the requirements of referenced specifications,
figures, drawings, and standards unless otherwise excluded, amended, modified, or qualified in this
specification or applicable documents (see 6.3 and 6.5).
4.5 Examination of end item. Examination of the end item shall be in accordance with
MIL-STD-105 and sections 4.5.1 and 4.5.2
4.5.1 Dimensional examinations. This examination shall be limited to those examinations that
may be performed without disassembling the unit in such manner that its performance, durability,
and appearance would be affected. The sample unit shall be one of the finished smoke curtains
or blankets. The sample size shall be in accordance with inspection level S-3. Smoke curtains and
blankets shall be examined in accordance with the length and width dimensions of Drawing
803-5959318.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals