 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-45300B
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
ASTM D3951
- Commercial Packaging, Practice for.
(Application for copies should be addressed to American Society for
Testing and Materials, 1916 Race Street, Philadelphia, PA, 19103.)
(Nongovernment standards and other publications are normally available
from the organizations which prepare or which distribute the documents.
These documents also may be available in or through libraries or other
informational services.)
2.3 Order of precedence. In the event of a conflict between the text of
this specification and the references cited herein (except for associated
detail specifications, specification sheets or MS standards), the text of
this `specification shall take precedence. Nothing in this specification,
however, shall supersede applicable laws and regulations unless a specific
exemption has been obtained.
3.
REQUIREMENTS
3.1 First article. Unless otherwise specified (see 6.2), the contractor
shall furnish caps, of the specified type (see 6.2), which shall be subjected
to first article inspection (see 4.4). First article inspection samples,
properly marked with identifying information shall be representative of the
caps co `be furnished to the Government. All subsequent caps delivered to the
Government shall conform to these samples in all of their pertinent physical
and performance attributes.
3.2 Materials (all types). Materials shall be as specified herein and
in referenced specifications, standards and drawings. Materials shall be
free of defects which adversely affect performance or serviceability of the
finished product (see 4.6.1).
3.2.1 Recycled, virgin and reclaimed materials. There are no
requirements for the exclusive use of virgin materials. The use of recycled
or reclaimed (recovered) materials is acceptable provided that all other
requirements of this specification are met (see 6.3.1).
3.3 Construction (all types) (see 4.6.1 and 4.6.2).
3.3.1 Type I.
Type I caps shall conform to MS51300.
3.3.2 Type II. Type II caps shall conform to MS35645.
Type III caps shall conform to MS53075.
3.3.3 Type III.
3.4 Performance.
3.4.1 Torque.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals