Inspection equipment

Page Title: Inspection equipment
Back | Up | Next

Web
www.tpub.com

Information Categories

....

MIL-C-45525B(WC)

4.5.2 Inspection equipment. Data lists containing equipment used in the

inspection of parts, subassemblies and assemblies are listed in DL 11577214.

4.5.2.1 Acquisition, maintenance, and disposition. Unless otherwise specified,

the contractor is responsible for acquisition, maintenance, and disposition

of acceptance inspection and test equipment prescribed in the List of Inspection

Equipment DL 11577214, and for all other inspection equipment required to per-

form inspection prescribed by applicable specifications.

4.5,2.2 Accuracy of standard measureing equipment. When commercial, and mod-

ified commercial inspection and test equipment is used, it shall be capable of

repetitive measurements to an accuracy of 10 percent of the total tolerance

of the characteristic being inspected.

4.5.3 Examination.

4.5.3.1 Primer headspace. Primer headspace shall be measured on each cannon

with the applicable gage or an approved equivalent gage. Cannons failing to

meet the requirements of 3.4 shall be rejected.

4.5.3.2 Firing Pin Protrusion and retraction. Firing pin protrusion and

retraction shall be gaged on each cannon with the applicable gages or with

approved equivalent gages. Cannons failing to meet the requirements of 3.5

shall be rejected.

4.5.3.3 preparation for delivery. The classification of defects and the AQL's

for examination of the packaging, packing, and marking are as follows:

Inspection

AQL Method

Defect