 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-48550(AR)
4.1.1 General provisions. - The component and subassembly inspection
requirements of MIL-F-13926 form a part of the Quality Assurance
Provisions of this specification. Definitions of inspection term
shall be as listed in MIL-STD-109.
4.2 First article (initial production)The approval. - The requirement
for first article approval and the responsibility (Government or
contractor) for first article testing shall be as specified in the
contract. The sample for first article approval tests shall consist
of three collimators plus three each of all items covered by SQAP.
The sample shall be manufactured In the same manner, using the same
materials, equipment, processes, and procedures that will be used
during production. All parts and materials, including packaging
shall be obtained from the same source of supply that will be used
during production.
4.2.1 Government testing. - When the Government is responsible for
conducting first article approval tests, the contractor, prior to
submitting the sample to the Government, shall inspect the sample
to insure that it conforms to all the requirements of the contract
and submit a record of this inspection with the sample, including
certificates of conformance for materials.
4.2.2 Contractor testing. - When the contractor is responsible for
conducting first article approval tests, the sample shall be inspected
by the contractor for all the requirements of the contractor.The
sample and a record of this inspection, including certificates of
conformance for materials, shall be submitted to the Government for
approval. The Government reserves the right to witness the contract-
or's inspection.
4.3 Inspection
provisions.
4.3.1 Submission of product. - Unless otherwise specified by the
contracting officer, inspection lot size, lot formation and present-
ation of lots shall be in accordance with "Submission of Product"
provisions of MIL-STD-105.
4.3.2 Examination
of
tests.
4.3.2.1 Components and subassemblies. -All components and subassem-
blies shall be inspected in accordance with the inspection provisions
contained in Supplementary Quality Assurance provisions (SQAP) listed
in the technical data package (TDP). In the absence of SQAP'S the
applicable Quality Assurance Provisions of MIL-F-13926 shall apply.
4.3.2.2 Final acceptance inspection. - The characteristics shown in
Tables II, III, IV, and the packaging and marking requirements of
4.3.2.2.2 shall constitute the minimum inspection to be performed
by supplier after first article approval and prior to Government
acceptance or rejection by item or lots
6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals