 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-50736(MU)
8 August 1973
4.3.2.2 Functional tests. The requirements and tests in table III
shall be inspected on a 100 percent basis. All examinations and tests shall
be conducted at the standard ambient temperature.
4.3.3 Acceptance and rejection. Rejected lots shall be screened
for all defective characteristics. Removal or correction of defective
units and resubmittance of rejected lots shall be in accordance with the
acceptance and rejection criteria specified in MIL-STD-105.
4.4 Special sampling. The selection of samples shall be in
accordance with section 7 of MIL-STD-105.
4.4.1 General. One assembly shall be selected at random by a
Government representative as a control sample from each 50 produced.
The control sample shall meet the requirements and tests in table IV.
4.4.2 Environmental. Three assemblies shall be selected at
random by a Government representative as a control sample from each
50 produced or from each month's production, whichever occurs first.
The control sample s shall meet the requirements and tests in table V.
4.4.3 Failure of sample. Should any one item of a special
sampling fail to meet the specified test requirements, acceptance of
the product shall be suspended by the Government until necessary
corrections have been made by the contractor and the resubmitted
item has been approved (see 4.3.3).
4.3 Inspection equipment. Except as otherwise provided for
by the contract the contractor shall supply and maintain inspection
equipment in accordance with the applicable requirements of MIL-I-
45607. The inspection equipment listed in table VI shall be utilized
in performing the tests specified herein.
TABLE VI
INSPECTION EQUIPMENT
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals