 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-63990C (AR)
NOTES
6.
(This section contains information of a general or explanatory
nature that may be helpful, but is not mandatory.)
6.1 Intended use. The components components covered by this
specification are intended for use in the cartridge, 5.56mm,
tracer, M856.
6.2 Acquisisttion requirements Acquisition documents must
specify the following:
Title, number and date of this specification.
a.
b. Issue of DODISS to be cited in the solicitation,
and, if required, the specific issue of individual documents
referenced (see 2.1.1).
Requirements for submission of first article
c.
sample.
Type and level of packing (see 5.1).
d.
Provision for submission of Inspection Equipment
e.
Designs.
f. Provision for submission of detailed inspection
plan for the cartridge (see 6.7).
g. Provisions for submission of acceptance inspection
results for each lot of ammunition presented to the Government
(see 6.6).
6.3 Submission of contractor inspection equipment designs
for approval. Submit copies of designs as required to:
Commander, U.S. Army ARDEC, ATTN: SMCAR-QAF-I, Picatinny
Arsenal, NJ 07806-5000. This address will be specified on the
Contract Data Requirements List, DD Form 1423 in the contract.
6.4 Hazard notice. The cartridge described herein and some
of its components are flammable or explosive and consequently
present hazards in manufacture,handling, storage and shipment
The contractor should recognize these hazards and take appro-
priate measure to prevent fire,explosion, adverse environment
rough handling, corrosive atmosphere, or electrically iduced
incidents. Such measures shall include the employment of an
effective safety program that addresses the inherent hazards
associated with the cartridge.
26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals