 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-64025(AR)
3.6.18.1 Initial status. After initial power application or
reassigning of the SEND or STORE codes, all groups shall begin with
the initial status of NONE when tested per 4.5.2.15 and 4.5.2.17.
3.6.18.2 Status update sequence. The group status shall be
updated as specified by the state diagram of Figure 4. when tested per
4.5.2.21, 4.5.2.23, and 4.5.7.31.4
RCU to CI transfer.
3.6.19.
3 .6.19.1
Transfer display.
The RCU shall momentarily display
(
"SENDING' when the TRANSFER key has been pressed, the RCU is in the
SEND mode, and the GROUP ID is not ALL when tested per 4.5.2,16.
3.6 .19.2 Transfer output.
When the load of Figure la is placed
on the RCU MCD coil as specified in that figure, an FSD pulse sequence
shall be generated at the output of the load as specified in Figure 2
for the current group and RCD code in response to a TRANSFER command
.
when tested per 4.5.2.16.
3.6.19.3 Group status update. When the waveform transmission
has completed, the group status display shall be updated as specified
by 3.6.18.2. and tested per 4.5.2.16.
.
.
3 .6.19.4 Invalid transfer Groupo The RCU shall display "ALL
INVALID", when the TRANSFER key is pressed, the RCU is in the SEND
mode,
and the GROUP ID is ALL when tested per 4.5.2.18.
3.6.20
RCU
command
transmission.
3 .6.20.1
Command display.
The RCU shall display "DEPLOY n",
"DESTRUCT n", or "RESET SD n", when the DEPLOY, DESTRUCT, or RESET SD
key respectively is pressed, - where n is the current GROUP ID number
and the RCU is in the SEND mode when tested per 4.5.2.19.
3 .6.20.2 Tuning sequence.
The RCU shall momentarily display
"TUNING" when the XMIT switch is pressed sequentially after the
DEPLOY, DESTRUCT, or RESET SD key and the RCU is in the SEND mode when
tested per 4.5.2.19.1.
3 .6.20.3 Transmit display.
The RCU shall display "XMIT TUNE =
m" where
m is an integer from O to 9 after the RCU has-completed the
tuning
sequence when tested per 4.5.2.19.2.
3 .6.20.4 RF output sequence.
An RF message, as specified by
Drawing 9333026 for the FSD data of the current group, shall be
generated after the RCU has completed the tuning sequence when tested
per 4.5.2.19.3.
3.6.20.5 Group-status
update. When the RF transmission has
completed, the group status shall be updated as specified by 3.6.18.2.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals