 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-64025(AR)
3.15 Qualified SUPPl iers. A qualified component supplier shall
be one who has successfully met the requirements of this specification
and First Article inspection specified herein.
3.16 Inspection data.
Data shall be recorded and retained for
all
first
article
and
Quality Conformance tests required by 4.4.2.TBD.
3.16.1 Variable data.
Transmitting power output,transmitting
current, standby current, power off current, "mark", frequency, "space",
frequency $ transmitter cutoff voltage and low-battery voltage shall be
measured and recorded as variable data for the first article samples
and surveillance units.
3.17 Surveillance units. . The contractor shall provide for
surveillance quantities of electronic assemblies from production.
Units shall be evenly proportioned from production. Inspection data
shall be recorded and retained for all surveillance units. Require-
ments, sample frequency and quantities for submission shall be as
specified in the contract.
3.18 First article inspection.
This specification contains
provisions for first article inspection. Requirements for the
submission of first article samples by the contractor shall be as
specified in the contract:
3.19 Electrostatic discharge control.
All areas where electronic
components , assemblies or equipment are present shall comply with the
requirements of the following control elements of DOD-STD-1686:
protected areas, handling procedures, protective covering,
installation site, training, quality
assurance provisions and
packaging for delivery.
3.20
Workmanship.
3.20.1
Mechanical
workmanship.
All parts and assemblies shall be
fabricated and assembled in a thorough, workmanlike manner. They shall
be free of burrs, sharp edges, cracks, dirt, grease, rust and other
foreign matter. The cleaning method used shall not be injurious to any
parts, nor shall the parts be contaminated by the cleaning agents.
Exterior surface coatings shall be continuous; however, light
scratches not exposing base material may be permitted. All required
marking and stamping shall be neat and sharply defined.
3.20.2 Electrical workmanship. Unless otherwise specified, all
soldering connections shall meet the requirements of MIL-S-45743,
MIL-S-46844 and the aplicable drawing. All other electrical
workmanship criteria shall meet MIL-STD-454, Req. 9 and the applicable
drawing.
22
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals