 |
|||
|
Page Title:
Table III. Classification of defects. |
|
||
| ||||||||||
|
|  MIL-C-70496(AR)
TABLE III.
Classification of defects.
No.
Characteristics
Requirement
Test Procedure
100% Inspection
1.
Power supply run
3.2.1.1
4.6.3.1
2.
Negative volts
3.2.1.2
4.6.3.2
3.
Positive volts
3.2.1.3
4.6.3.3
4.
Output ripple
3.2.1.4
4.6.3.4
5.
Overload/shortcircuit
protection
3.2.1.5
4.6.3.5
6.
Reset
3.2.1.6
4.6.3.6
7.
Power supply fault
3.2.1.7
4.6.3.7
8.
Power supply volts
3.2.1.8
4.6.3.8
9.
Supply positive
3.2.1.9
4.6.3.9
10.
Battery low
3.2.1.10
4.6.3.10
11.
Common connector
contact continuity
3.2.1.11
4.6.4
12.
ESS temperature
3.3.2
4.6.1
13.
ESS vibration
3.3.3
4.6.2
MAJOR:
AQL 1.0% Defective
101.
Workmanship
3.6
4.6.5
4.4.2 Special sampling. One supply shall be selected at
random as a special sample from each lot or each 100 produced which
ever occurs first. The sample shall meet the requirements and
tests in Table IV.
TABLE IV.
Classification of defects.
No.
Characteristics
Requirement
Test Procedure
201.
Fabrication
3.4
Applicable Drawing\
Visual
202.
Materials
3.7
Applicable Drawing/
Visual
NOTE:
The tests in Table IV shall be conducted at room ambient
temperature (as specified in 3.3.1).
4.4.3 Failure of sample. Should any one item of a special
sampling fail to meet the specified test requirements, acceptance
of the represented inspection lot will be suspended by the
Government until necessary corrections have been made by the
contractor and resubmitted items have been approved in accordance
with "Acceptance and Rejection" as specified in MIL-STD-105.
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals