 |
|||
|
Page Title:
Visual examination qualification |
|
||
| ||||||||||
|
|  MIL-C-70678 (AR)
NOTES
6.
6.1 Intended use. The components covered by this
specification are intended for assembly to XM722 smoke cartridges
for use on the 60mm mortar.
6.2 Visual examination qualification. When compliance with
the applicable requirement is in doubt as a result of visual
examination, this characteristic may be measured or gaged to
determine acceptability. The roughness comparison specimens
prescribed by ANSI-B46.1 shall be used as the basis for surface
roughness determination.
6.3 Ordering data. See MIL-A-48078.
6.4 Submission of inspection equipment designs for
approvals. See MIL-A-48078. Submit designs as required to
Commander, U.S. Army, ARDEC, ATTN: AMSMC-QAT-I (D), Bldg 62,
Picatinny Arsenal, NJ 07806-5000. This address will be specified
on the Contract Data Requirements List, DD form 1423 in the
contract. Unless otherwise specified, data item DI-R-1714 will
apply.
6.5 Drawings. Drawings listed in Section 2 of this
specification under the headings US Army Armament Research
Development and Engineering Center (ARDEC) may also include
drawings prepared by, and identified by as Edgewood Arsenal,
Frankford Arsenal, Rock Island Arsenal, Picatinny Arsenal or
ARRADCOM drawings. Technical data originally prepared by these
activities is now under the cognizance of ARDEC.
6.6 Subject term (key word) listing.
Case, burster
Leak, air
Specimens, tensile
Spray, salt
Varnish, phenolic baking
Preparing activity
Custodian:
Army-AR
Army-AR
(Project 1310-A425)
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals