 |
|||
|
|
|||
| ||||||||||
|
|  MILC-7094Z (AR)
4.1.1 Responsibility for compliance. All items must meet
all requirements of sections 3 and 5 and all applicable drawings.
The inspection set forth in this specification shall become a
part of the contractor's overall inspection system Or quality
program. The absence of any inspection requirements in the
specification shall not relieve the contractor of the
responsibility of assuring that all products or supplies
submitted to the Government for acceptance comply with all
requirements of the contract. Sampling in quality conformance
does not authorize submission of known defective material, either
indicated or actual, nor does it commit the Government to
acceptance of defective material.
4.1.2 General provisions . The component and subassembly
inspection requirements of MIL-F-13926 and MIL-STD-454 forms a
part of the Quality Assurance Provisions of this specifications.
4.2 Classification of inspections. The inspection
requirements specified herein are classified as follows:
First article inspection (see 4.3).
Quality conformance inspection (see 4.4).
b.
c.
Special sampling (see 4.5).
4.2.1 Inspection conditions. Unless otherwise specified,
all examinations and tests shall be conducted at the following
standard ambient conditions:
+60 degrees to +90 degrees F.
Temperature
90% RH maximum.
b.
Relative humidity
28 to 32 inches of Hg.
Pressure
c.
4.3 First article inspection.
4.3.1 First article submission. The contractor shall submit
a first article sample as designated by the contracting officer
consisting of three CCA for inspection in accordance with 4.3.2.
to be Performed. First article
4.3.2 Inspections
assemblies, components and test specimens may be subjected by the
Government to any or all of the examinations and tests specified
in TABLE II and TABLE III herein and to any or all requirements
of the applicable drawings.
If any assembly, component or test
4.3.3 R e j e c t i o n .
specimen fails to comply with any of the applicable requirements,
the first article sample shall be rejected. The Government
reserves the right to terminate its inspection upon any failure
of any CCA to comply with any of the stated requirements.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals