 |
|||
|
Page Title:
Quality conformance inspection. |
|
||
| ||||||||||
|
|  MIL-C-70942 (AR)
4 . 4 Quality conformance inspection.
4 .4.1 Inspection lot formation. The term "inspection lot"
is defined as a homogeneous collection of units of product from
which a representative sample is drawn or which is inspected 100
percent to determine conformance with applicable requirements.
Units of product selected for inspection shall represent only the
inspection lot from which they are drawn and shall not be
construed to represent any prior or subsequent quantities
presented for inspection. Homogeneity shall be considered to
exist provided the inspection lot has been produced by one
manufacturer, in one unchanged process, using the same materials
and methods, in accordance with the same drawings, same drawing
revisions, same specifications and same specification revisions,
and complies with the provisions for submission of product as
specified in MIL-STD-105. All material submitted for inspection
in accordance with this specification shall comply with the
homogeneity criteria specified herein, regardless of the type of
inspection procedure which is being applied to determine
conformance with requirements.
4.4.2 Examinations and tests.
4.4.2.1 Components, assemblies and subassemblies. Al 1
components, assemblies and subassemblies shall be inspected in
accordance with the inspection provisions contained in this
specification and Quality Assurance Provisions (QAP) listed in
the Technical Data Package (TDP) . In the absence of QAPs, the
applicable quality assurance provisions of MIL-F-13926 shall
apply.
4.4.2.2 Final acceptance inspection. Subsequent to first
article approval, examination and tests related to Section 3
herein shall be performed in accordance with the sampling plans
specified in 4.4.2.3 herein. Examination and test for packaging
and marking shall be in accordance with MIL-P-14232 and Section 5
herein. The tabulated classification of defects in 4.4.2.3 shall
constitute the minimum inspection to be performed by the supplier
after first article approval and prior to Government acceptance
or rejection by item or lot.
4.4.2.3 Functional tests. The tests in TABLE II shall be
performed as noted under the characteristics.
TABLE II.
Functional tests
(100% Inspection)
No.
Characteristics
Re quirement
Test Procedure
Critical:
None
None
N/A
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals