 |
|||
|
Page Title:
Stacking Frames/Cradle configuration tests. |
|
||
| ||||||||||
|
|  MIL-C-81313 (WP)
MHU-62/E. . T h e MHU-62/E Multiple Bomb Cradle
4.3.3.1
shall be loaded with six cyl inders, nine inches in diameter,
e a c h weighing not less than 350 nor more than 500 pounds and
then with six cylinders, 10-3/4 inches in diameter, each weigh-
i n g not less than 350 nor more than 500 pounds.
MHU-63/E. - T h e MHU-63/E Small Universal
4.3.3.2
Cradle shall be loaded with a cylinder eight inches in diameter,
w e i g h i n g not less than 100 pounds nor more than 400 pounds and
then with a cylinder 16 inches in diameter, weighing not less
t h a n 200 pounds nor more than 500 pounds.
MHU-65/E. - The MHU-65/E Large Universal
4.3*3*3
Cradle shall be loaded with a cylinder 16 inches in diameter,
w e i g h i n g not less than 300 pounds nor more than 700 pounds
and then with a cylinder 32 inches in diameter, weighing not
l e s s than 600 pounds nor more than 1,000 pounds.
MHU-61/E. - The MHU-61/E SIDEWINDER Cradle
4.3.3.4
shall be loaded with four SIDEWINDER Missiles or dynamically
The Government will either supply missiles
simulated shapes.
or shapes for this test or will furnish design data for the
contractor to manufacture test shapes (see 6.2).
Stacking Frames/Cradle configuration tests.
-
4.3.4
The Cradles and Stacking Frames shall be tested as follows to
insure compliance with stacking requirements.
MHU-64/E. - The MHU-64\E Small Stacking
4.3.4.1
Frame shall be used in pairs to support a stack of three loaded
(see 4.3.3.2) Small Universal Cradles. A random method of
parts selection shall be used when this test is performed and
the positive lock depicted on applicable drawings shall be
maintained between the Stacking Frame and the Cradle. No
evidence of permanent set or deformation to any of the parts
shall be found during or after this test.
MHU-66/E. - T h e MHU-66/E Large Stacking
4.3.4.2
Frame shall be used in pairs to support a stack of two loaded
(see 4.3.3.3) Large Universal Cradles. A random method of
parts selection shall be uses when this test is performed and
the positive lock depicted on applicable drawings shall be
m a i n t a i n e d b e t w e e n t h e S t a c k i n g F r a m e a n d t h e C r a d l e . NO
evidence of permanent set or deformation to any of the parts
shall be found during or after this test.
8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals