 |
|||
|
Page Title:
Table II. Vehicular electrical system. |
|
||
| ||||||||||
|
|  MIL-D-435F(ME)
3.4.13.2 Brake lining. The brake linings shall be of the nonasbestos and of the nonfading
from heat and from water immersion type. The lining shall be of the standard size as listed in the
Automotive Data Book of the Friction Materials Standards Institute, Inc.
3.4.13.3 Brake lines. The brake lines shall be routed within the protection of the framing
members and shall be supported and secured by cushioned clamps at intervals not greater than
3 feet. At each point where the brake lines pass through metal members, the lines shall be
protected by a rubber or nylon grommet and tightly secured, or a through-frame connector shall
be used. The routing and connection locations shall facilitate replacement of the brake lines
from bulk supply.
3.4.14 Chock blocks. A chock block conforming to figure 1 shall be provided for each
wheel. The captive chains shall permit placing the chock block both to the front and to the rear
of each wheel.
3.4.15 Vehicular electrical system. When specified (see 6.2), the distributor shall be
equipped with a waterproof, 12-volt vehicular electrical system. Except as specified herein, the
electrical system shall be in accordance with the following requirements:
a.
DOT Federal Motor Vehicle Safety Standards (FMVSS).
b.
DOT Federal Motor Carrier Safety Regulations (FMCSR).
c.
SAE Handbook, Electrical Equipment and Lighting Section.
d.
TTMA Recommended Practices RP No. 6, RP No. 9, RP No. 14, RP No. 40, and
Technical Bulletin No. 65.
All components shall be provided with the maximum practical protection from damage, shock,
and vibration through means of location and resilient mounts. The electrical components shall
be in accordance with table II. Item quantities that are not specified shall be furnished as
required (AR) for each distributor.
TABLE II. Vehicular electrical system.
Description
Requirements
Quantity Per
heater
7 conductor plus and
SAE J560 and TTMA RP#40, 7-wire type with
1 ea
intervehicular harness
plated metal connectors, splash proof plug cover.
assembly
SAE J1067 seven conductor jacketed cable
fastened to connection box.
Splash proof type with stud and nut terminals.
1 ea min
Connection box
Circuit breakers
SAE J553 protecting all live circuits.
AR
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals