 |
|||
|
|
|||
| ||||||||||
|
|  MIL-D-537F
NATIONAL MOTOR FREIGHT TRAFFIC ASSOCIATION, INC., AGENT
National Motor Freight Classification
(Application for copies should be addressed to the American Trucking Association, Inc.,
ATTN: Traffic Order Section, 2200 Mill Road, Alexandria, VA 22314.)
UNIFORM CLASSIFICATION COMMITTEE AGENT
Uniform Freight Classification Rules
(Application for copies should be addressed to Uniform Classification Committee,
ATTN: Tariff Publishing Officer, Room 1106, 222 S. Riverside Plaza, Chicago, IL 60606.)
(Nongovernment standards and other publications are normally available from the
organizations that prepare or distribute the documents. These documents also may be available in
or through libraries or other informational services.)
2.3 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein, the text of this document shall take precedence. Nothing in this
document, however, shall supersede applicable laws and regulations unless a specific exemption
has been obtained.
3. REQUIREMENTS
3.1 Description. The disks shall be in accordance with TA13200E7430 and as specified
herein.
3.1.1 Drawings. The drawings forming a part of this specification are end product drawings.
No deviation from the prescribed dimensions or tolerances is permissible without prior approval
of the contracting officer. Where tolerances could cumulatively result in incorrect fits, the
contractor shall provide tolerances within those prescribed on the drawings to insure correct fit,
assembly, and operation of the disks. Any data (e.g. shop drawings, layouts, flow sheets,
processing procedures, etc.) prepared by the contractor or obtained from a vendor to support
fabrication and manufacture of the production item shall be made available, upon request, for
inspection by the contracting officer or his designated representative.
3.2 First article. Unless otherwise specified (see 6.2), a sample shall be subjected to first
article inspection (see 6.3) in accordance with 4.3.
3.3 Materials. Materials shall be as specified herein and on the drawings. Materials not
specified shall be selected by the contractor and shall be subject to all provisions of this
specification.
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals