 |
|||
|
|
|||
| ||||||||||
|
|  MIL-E-63124B(AR)
AMENDMENT 2
4.5.3 Low temperature, line 2: Delete "MIL-STD-810C, Test
Method 502,1" and substitute `MIL-STD-810, Test Method 502.3,
procedure II, Severe Cold",
4.5.4 Helicopter vibration.
Line 2: Delete "MIL-STD-810C, Test Method 514.2, procedure
IIC, . .." and substitute `MIL-STD-810, Method 514.4, Category
7C, ..*"*
Line 5: Delete "... in Figure 1. The payload . . . for this
test" and substitute "... in Figure 2. The payload module
shall be loaded with thirty (30) ballast flares, dwg.
12589959, (preferred) or with thirty (30) inert flares for
this test".
*
4.5.5 Transportation vibration, line 2: Delete MIL-STD-810C
5 and 6 HZ)" and substitute `MIL-STD-810, Method 514.4, Basic
Transportation, Category I".
PAGE 32
*
4.5.6 Humidity, line 2: Delete "MIL-STD-810C . . . .(10 days)"
and substitute "MIL_STD_810 r Method 507.3, Procedure III".
*
4.5.8 Seal integrity:
First sentence: Delete " . ..programmer module (Dwg. 9311429)
... " and substitute " . ..electronics module assembly (Dwg.
9311431) ..*".
Last sentence: Delete " . ..program module . .." and
substitute " . ..electronics module assembly . ..".
The margins of this amendment are marked with an asterisk or
vertical lines to indicate where changes (additions,
modifications, corrections, deletions) from the previous
amendment were made. This was done as a convenience only and
the Government assumes no liability whatsoever for any
inaccuracies in these notations. Bidders and contractors are
cautioned to evaluate the requirements of this document based on
the entire content irrespective of the marginal notations and
relationship to the last previous amendment.
Preparing activity:
Custodian:
Army-AR
Army-AR
(Project 1095-A269)
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals