 |
|||
|
Page Title:
Table I. Fuze Function Control Set AN/AWW-1 Adjustments and Output Requirements |
|
||
| ||||||||||
|
| Table I
FUZE FUNCTION CONTROL SET AN/AWW-l$ ADJUSTMENTS AND OUTPUT REQUIREMENTS
(FUZE FUNCTION CONTROL C-2612/AWW-1 REMOVED)
INSTRUCTIONS:
(1) Ground pin J of J1203.
(2) Apply 115 volts, 400 cps to pins m, f, and g of J1203; if single phase is used, pins m, f, and
g must be tied together,
(3) The voltage measured between pin A of J1204 and each of the pins a, b, and c of J1204 shall
be 115 * 10 volts, 400 * 20 Cps.
(4) Apply +28 volts d-c to pins c and d (tied together) of J1203.
(5) Apply + 28 volts d-c to pin B of J1204.
(6) Adjust R1201 for r-f bias of -55.0 *O. 3 volts d-c.
(7) Adjust R1204 for r-f supply of 300.0 1.5 volts d-c.
(8) Adjust R1203 for 300 1.5 volts d-c. Measure between pin B of J1202 and ground with no
load after a 15-minute warmup period.
(9) Adjust R1202 for 195 1 volts d-c. Measure between pin B of J1202 and ground with no load
after a 15-minute warmup period.
COLUMN HEADINGS
1 Template number
Oscillator plug-in socket
.
3 Channel number
.
4 Pins to be grounded on J1203
5 Resistor to be adjusted for r-f voltage output of 12 +0/-0.5 volts (rms); measured between pins
A and B of J1202 across a 30 ohm load after a 15 minute warmup period
6 Regulated r-f output (volts rms) measured between pins A and B of J1202 across loads ranging
from 30 to 120 ohms
7 R e q u i r e d frequency in kilocycles
8 D-C load (ohms) between pin B of J1202 and ground
9 D-C voltage (volts) measured between pin B of J1202 and ground
COLUMN HEADINGS ARE GIVEN ABOVE
7
8
4
6
9
1
2
3
5
12 +1.4
.
250,00 1.25
H
R1301
I
XY1301
6
.
-1.7
12 +1.4
340,00 1.70
c
R1302
XY1302
4
-1.7
XY1303
-
12 +1.4
E
184.00 0.92
XY1304
8
R1304
-1.7
300 6
All of
6,4,8
H,C,
E
-
17.3
*5.2
-
10,000
above
12 +1. 4
XY1301
1
R1301
539.00 2.69
II
H
lW
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals